Knowledge Hub

Learn how Machine Learning and 3D inverse design optimize centrifugal compressors using advanced turbomachinery design techniques. 

In this webinar,  a methodology for High-temperature heat pumps (HTHP) centrifugal compressor design is presented. The heat pump cycle analysis and the compressor meanline design are coupled in the initial phase to study the selection of refrigerants and their impact on compressor design. Following this, the impeller was designed using a 3D inverse design method.

In this webinar,  we propose to use some aerodynamic and mechanical performance parameters from an inverse design solution and a direct optimisation approach to perform the multidisciplinary optimisation.

In this webinar, we’ll show the novel design and optimisation strategy coupling the 3D inverse approach and DoE study that is developed to design a transonic centrifugal impeller. The redesigned compressor has better efficiency across most parts of the map, and the maximum pressure ratio is also slightly improved.

This joint webinar by Advanced Design Technology and Gamma Technologies presents a novel methodology that uses a system-level simulation platform (GT-SUITE) to create a complete vehicle model and simulate the performance of a fuel cell powered truck in order to obtain the key compressor operating points. 

In this webinar, you will learn how to optimise blade loading in centrifugal compressors, which can massively enhance the performance compared to conventional centrifugal compressors blade loading designs. And discover how 3D inverse design can be used to efficiently design centrifugal compressors with optimum blade loading.

In this webinar, you will learn how tandem-blade centrifugal compressors can provide performance improvements in relation to conventional full blade designs and discover how 3D inverse design can be used to efficiently design centrifugal compressors with tandem-blade configuration. 

This webinar presents the redesign of an electrically driven mixed flow transonic compressor by using a 3D inverse design methodology. The compressor will be used for an active high-lift system application that aims to delay the onset of stall and thus contributing to the reduction of both the aircraft noise footprint and the impact of aviation emission on local air quality.

Discover how to design a supercritical co2 compressor and turbine for a 10MW system in the latest ADT webinar